Resetting the programmed LockNode and programmed locking device - Step-by-Step WO

Resetting the LockNode

  1. SmartIntego-Tool (WO) opened.
  2. Second locking device of the same type available.
  3. GatewayNode available.
  4. SI.SmartCD available.
  1. Create a second project with a different SID in the SmartIntego tool (WO) (see Createing a SmartIntego project).
  2. Add the GatewayNode to this project (see Add GatewayNode).
  3. Add the second locking device (see Add LockNodes).
  4. Program the LockNode of the second locking device and the second locking device (see Programme locking device).
  5. Second system set up.
  6. Remove the LockNode from the old locking device (see quick guide or manual).
  7. Remove the LockNode from the second locking device (see quick guide or manual).
  8. Install the LockNode of the old locking device in the second locking device.
  9. The locking device beeps and flashes red four times.
  10. Remove the LockNode of the old locking device from the second locking device.
  11. Reinstall the LockNode of the old locking device into the old locking device.
  12. The locking device beeps and flashes red four times.
  1. LockNode is reset.
  2. Then reset the second locking device, LockNode and GatewayNode with SmartIntego Manager and the SmartIntego tool (WO) if necessary.

Re-set locking device

  1. SmartIntego-Tool (WO) opened.
  2. LockNode reset as described.
  1. Position the programming device on the locking device (example: locking cylinder).
  3. Read the locking device using Tools Card Reader and Read unknown lock.
  5. Summary of the read locking device is displayed.
  7. Click on the Reset button
  8. Locking system password is queried.
  10. Enter the locking system password.
  11. Click on the button OK.
  12. The locking device is reset.
  1. Locking device and LockNode reset.