Resetting components with hardware reset - Step-by-Step WO

If you can no longer reset the components with SmartIntego Manager (see Resetting components with SmartIntego software), you must use the hardware reset.

Possible causes:

• The data of a component has been deleted in the SmartIntego tool (WO) without deleting the component in the SmartIntego tool (WO). This means that the SmartIntego tool (WO) can no longer reach the component.
• The SmartIntego tool (WO) configuration file (*.ikp) no longer exists.
• The existing data status deviates from the real project in both cases. The system attempts to address components that no longer exist with the existing addressing. You must correct the deviation yourself.
• Reset the components in the following order:

1. LockNode
2. Locking device
3. GatewayNode (after resetting all connected LockNodes and locking devices, see Resetting the WaveNet/network configuration of the GatewayNode)
4. Depending on the situation, you must deviate from this sequence.

The procedure differs depending on the status of the locking device in which the LockNode is installed.

• Programmed LockNode in programmed locking device (see Resetting the programmed LockNode and programmed locking device).
• Programmed LockNode in non-programmed locking device (see Resetting the programmed LockNode and non-programmed locking device).

LockNodes are reset as soon as they are installed in a programmed locking device in which a previously programmed LockNode was already installed.