Install SmartIntego tool - Step-by-Step WO

Install the SmartIntego tool (WO) on a PC or laptop with USB connection.

  1. Administrator rights available.
  1. Run the SmartIntego_setup_X_X_WO.exe file.
  2. Follow the instructions.
  3. Install SmartIntego tool (WO).
  4. SmartIntego Manager installed.
  5. Driver for SI.SmartCD installed.
  6. After installation, connect the SI.SmartCD programming device.
  7. Open any existing project file.

The card configuration for the locking devices must be fully loaded. When programming the first locking device, connect the programming device (SI.SmartCD) to a USB port on the PC. The locking device itself is programmed via WaveNet.

You can also use the SmartIntego tool (WO) later without a local programming device (e.g. on a virtual server).

NOTE

notice

Descriptions in this document

The descriptions in this document refer to SmartIntego tool (WO) version 3.0 or higher.

  1. Use the latest version of the SmartIntego tool (WO).