TCP: On-site installation (manual WaveNet configuration) - Step-by-Step WO

  1. Integrator system prepared.
  2. Cables and connections available.
  3. Assign IP addresses (TCP only).
  4. Customer informed about the process.
  5. SmartIntego components already delivered.
  6. Names of the doors are fixed.
  1. Label the components.
  2. If necessary, set up the name list of the doors (see Creating, expanding and importing a name list).
  3. Create the system documentation (see Document system). The system documentation shows what has been installed where.
  4. Configure your GatewayNodes (see Configuring GatewayNodes (TCP)).
  5. Mount your GatewayNodes.
  6. Install the SmartIntego tool (WO) (see Install SmartIntego tool).
  7. Create your SmartIntego project (see Createing a SmartIntego project).
  8. Set up your card configuration (see Card configuration setup).
  9. Mount your locking devices. Alternatively, you can also place your locking devices in front of the doors and install them after programming.

  10. NOTE

    notice

    Unprotected rooms and relocated locks

    The locking devices can be opened with any card in non-programmed state. The rooms are only protected once the locking devices have been programmed.

    Locking devices in front of the door can be relocated or escaped by third parties.

    1. Inform all persons in the property that the position of the locking devices must not be changed and that no locking devices may be stolen
  11. Set up SmartIntego Manager (see Setting up SmartIntego Manager).
  12. Add multiple GatewayNodes (IP range) (see TCP: Add multiple GatewayNodes (IP range)).
  13. Add several LockNodes manually (see Add multiple LockNodes (Manual)) and add additional LockNodes manually if necessary (see Add individual LockNodes).
  14. If necessary, manage your locking devices in the SmartIntego tool (WO) (see Managing locking devices in the SmartIntego tool (WO)).
  15. Programme your locking devices (see Programme hybrid locking devices).
  16. Mount if necessary. Your locking devices that have not yet been installed.
  17. After making changes, connect your SmartIntego locking system to the integrator system (see Connecting SmartIntego to the integrator system).
  18. Test the system.

Always compare your SmartIntego locking system with the integrator system after making changes.