TCP: Installation according to WaveNet illumination - Step-by-Step WO

Use this procedure to commission the system manually according to the results of the illumination (see Illuminate WaveNet). This description applies to the preparation at the installer and installation at the customer's premises.

Preparing the installer

Your locking devices can remain collected in the box.

  1. Network cable available to connect each GatewayNode.
  2. If possible, all subsequent GatewayNodes are connected to a separate network.
  3. Final IP configuration known (obtain from end customer if necessary).
  4. SmartIntego components already delivered.
  5. Name list for the door known (obtain from end customer if necessary).
  6. Integrator system configured.
  1. Label the components.
  2. Set up the door name list (see Creating, expanding and importing a name list).
  3. Create the system documentation (see Document system). The system documentation shows what has been installed where.
  4. Connect the configuration PC to your GatewayNodes.
  5. Configure your GatewayNodes (see Configuring GatewayNodes (TCP)).
  6. Create your SmartIntego project (see Createing a SmartIntego project).
  7. Set up your card configuration (see Card configuration setup).
  8. Set up SmartIntego Manager (see Setting up SmartIntego Manager).
  9. Add individual GatewayNodes (see TCP: Add individual GatewayNodes).
  10. Manually add several LockNodes (see Add multiple LockNodes (Manual)) and add additional LockNodes manually (see Add individual LockNodes).
  11. If necessary, manage your locking devices in the SmartIntego tool (WO) (see Managing locking devices in the SmartIntego tool (WO)).
  12. Programme your locking devices (see Programme hybrid locking devices).
  13. Repeat steps 6, 7, 10, 11 and 13 for each GatewayNode.
  14. After making changes, connect your SmartIntego locking system to the integrator system (see Connecting SmartIntego to the integrator system).
  15. Transfer the integrator whitelist to your locking devices.

Always compare your SmartIntego locking system with the integrator system after making changes.

Installation at the customer's site

  1. Completed installer sequence.
  1. Set up the infrastructure for your locking system in the property.
  2. Mount your GatewayNodes.
  3. Hand out the cards (if not done yet).
  4. Mount the locking devices in the object.

  5. IMPORTANT

    Discharging the batteries

    Operation exclusively via the whitelist is only recommended temporarily. The locking devices do not issue battery warnings. You will not be informed about low batteries.

  6. Check the WaveNet (see Check WaveNet).
  7. If necessary, change the assignment of LockNodes to the GatewayNodes (see Automatically assign LockNodes).
  8. After making changes, connect your SmartIntego locking system to the integrator system (see Connecting SmartIntego to the integrator system).
  9. Test the system.