Input (push-pull) - WaveNet

Use this setup to switch an input with a push-pull output. The push-pull output can be regulated by an external system. This allows you to connect an external system to the WaveNet.

  1. Connect the ground potentials of the signal transmitter and the router node.
  2. Connect the push-pull output of the signal transmitter to one of the digital inputs DI1, DI2 or DI3.

IMPORTANT

Voltage ranges of the digital inputs

The push-pull output can work with unsuitable voltages. For the signal to be reliably recognized as HIGH and LOW, it must be above or below the reference voltages, depending on the signal level. The maximum output voltage of the push-pull output must not exceed 3.3 VDC.

  1. Do not use push-pull outputs whose voltage values for HIGH and LOW do not match the equivalent voltages of RouterNode 2.
  2. Do not use push-pull outputs whose maximum output voltage exceeds 3.3 VDC.

Comparison voltages (RN and RN2)

<0,9 VDC

LOW (no signal)

>2.1 VDC

HIGH (signal)