Reader - SmartRelay 3 system

The reader can be mounted in any position.

IMPORTANT

Adverse effect on reception due to interferences

This device communicates wirelessly. Wireless communication can be affected or may fail due to metal surfaces or interference.

  1. Do not fit the device to metal surfaces.
  2. Keep the device away from sources of electrical or magnetic interference.

Malfunctions due to weather conditions

In the standard version, the reader is not protected against splash water and other weather influences.

  1. If you want to use the reader in an environment that is not protected against splash water, use the WP variant.
  2. Ensure complete protection against splash water by means of additional sealing.

Transmission errors due to unshielded cable

Unshielded cables are more susceptible to interference.

  1. Use shielded cables for the connection to the reader (see Information on cabling and Block diagrams).

The following graphics and instructions refer to the LED reader. A normal reader is installed in a similar way.

  1. Have a slotted-head screwdriver ready.
  1. Place the reader on the lid.
  2. Use a slotted-head screwdriver to push one of the clips inwards.
  4. Press and hold the clip down and use the slotted screwdriver to slide the base plate upwards.
  6. Clip stays pressed down.
  7. Do the same with the other clip.
  8. Insert the screwdriver into the hole and lever the base plate out of the lid.
  10. Base plate and lid are separated.
  11. Fasten the base plate in its required location (see Determining installation position for an external reader).
  12. Wire the reader (see Connections).
  13. Place the lid on the base plate again.
  1. Reader is installed.