Unpacking and system test - SmartRelay 3 system

Scope of delivery

Check to ensure the supply package is complete after receiving it. Unless agreed otherwise, the supply package contains the following components:

Controller

Controller

1x

Instruction leaflet

1x

Reader

Reader

1x

Instruction leaflet

1x

SmartOutput module

SmartOutput module

1x

Jumpers (pre-assembled)

2x

Instruction leaflet

1x

System test

You can check the supplied components to ensure they function correctly before installation and programming. Proceed as follows:

  1. Wire the components (see wiring).
  2. Connect the components to the power supply (connect the controller last).
  3. Wait a few seconds until all components are ready for operation.
  4. Controller flashes all colours first and then green.
  5. Reader flashes all colours first, beeps and then no longer flashes.
  6. Optional SmartOutput module: Relay contacts are open (indicated by LEDs and a tick-tack sound), then flashes green.
  7. Use an identification medium on the reader (empty transponders or empty DESFIRE card).
  1. Reader flashes green twice and beeps.
  2. The relay built into controller actuates (Contacts 3, 4 and 5).