Reading the access list over network - SmartRelay 3 system

Proceed as follows if you wish to read the access list using a network connection:

  1. Components wired correctly (see wiring).
  2. Components connected to power.
  3. Controller has already been programmed.
  4. Controller connected to computer via network.
  1. Mark the entry on the SmartRelay 3 controller in the matrix.
  2. Use Programming to select the Read highlighted locking device/set time item.
  4. The Read lock window will open.
  6. Open the Type drop-down menu.
  8. Select the TCP nodes item.
  9. Click on the Read button.
  10. Locking device is read.
  11. The G2 Smart Relay 3 window will open.
  12. Click on the Read button.
  13. Click on the Audit Trail button.
  1. Access list is displayed.