Emergency battery storage mode (G1) - SmartHandle 3062

G1 SmartHandle automatically switches to emergency battery storage mode if Battery Warning Levels 1 and 2 have not been observed or the locking system administrator has not been informed of battery warning. User transponders can no longer activate a G1 SmartHandle to prevent the battery from being fully discharged in this status.

NOTE

notice

This state should never occur because the batteries have to be changed at an early stage, i.e. in battery warning level 1!

The system administrator is required to open the door or to change the batteries (see Battery replacement). If the door is locked, the administrator will need to carry out the following steps; if the door is open or the battery side is accessible, there is no need to complete these steps

  • Re-programme SmartHandle (this deactivates storage mode)
  • Use an authorised transponder to engage the locking cylinder and open the door (the lock will automatically switch to storage mode again)
  • Replace the batteries
  • Re-programme SmartHandle (to deactivate storage mode permanently)

After the door is opened, Battery Warning Level 2 is emitted one more time and then the lock is available again as normal.