Restore storage mode for Snap-in - SmartHandle 3062

  1. Disconnect the 3-pole cable from the inside fitting to the 3-pole cable from the outer fitting. If necessary, also disconnect the LockNode cable from the inside fitting.
  2. Undo mounting screw (9) in the inside fitting (8) about 1 cm.
  3. Use a soft object to knock on the mounting screw (9) to release the tension in the snap-in mechanism (7).
  4. Undo mounting screw (9) fully.
  5. Hold the inside and outer fittings firmly while carefully pulling them away from one another horizontally.

Fitted to the door:

NOTE

notice

General instructions: Depending on the handle model, it may not be possible to remove the inlay immediately. In such a case, push the inlay through the opening in the cover and remove the cover. The inlay remains on the handle and cannot be removed until the handle is dismounted.

Follow the same steps as for installation but in reverse order.