Procedure for freeze mode (G1) - SmartHandle 3062

If battery warning levels 1 and 2 are not observed or the locking system administrator has not been informed, the SmartHandle 3062 automatically switches to freeze mode. User ID media can then no longer activate the SmartHandle 3062 to prevent the battery from being fully discharged in this status.

NOTE

notice

This state should never occur because the batteries have to be changed at an early stage, i.e. in battery warning level 1!

The system administrator is required to open the door or replace batteries (see Battery Replacement section for further details). The administrator will need to carry out the following steps if the door is locked: Disregard the first point if the door is open or if the battery side is accessible.

  • If the door is locked, the administrator will need to activate the door with a battery replacement ID medium, thus eliminating freeze mode.
  • Activate SmartHandle with an authorised ID medium and open door. The locking device will then switch back immediately to freeze mode
  • Replace the batteries
  • Activate the door with the battery replacement ID medium again, thus eliminating freeze mode permanently after the batteries are checked.

NOTE

notice

Now replace all used batteries with new ones immediately since the entire electronics module can fail otherwise!