Step 4: Installation of fittings - SmartHandle 3062

  1. Position installation tool through the profile cylinder opening in the door lock, so that the plug remains on the outer side.
  2. Push the inside fitting spindle through the retainer slot in the door's mortise lock, so that the fitting is flush with the door.
  3. Cables for fastening screw and bolt buttons and the installation tool must be fed through the snap-in mechanism to the inner side.
  4. The inside fitting is now firmly placed flat against the door. The cables and installation tool run downwards on the inside of the door. If a two-wire cable should be too short, a extension/adapter cable can be used.
  5. Use the installation tool to connect four-wire cables from the outer fitting.
  6. Push plug out horizontally, directly beneath the snap-in mechanism, and to the inner side. The outer fitting must be joined together with the inside fitting at the same time by inserting the outer fitting bolt into the inner fitting's snap-in shaft.

  7. NOTE

    notice

    Ensure that no cabling gets caught or broken.

  8. Screw inside fitting together with the outer fitting from the inside. Ensure that the fitting is positioned in parallel to the door.
  9. Inside and outer fitting are now firmly joined together flat against the door.
  10. Connect cables. The two two-pole cables and the four-pole cable are to be properly connected to one another. The two-pole cables can be connected to one another as desired.
  11. Lay cables in such a way that the cover can be easily fitted. Make sure that you do not crush the cables.