Step 0: Preparing drill holes - SmartHandle 3062

NOTE

notice

The mortise lock must be removed from the lock before drilling to avoid damaging it. The door lock can be re-fitted to the door once drilling is complete.

NOTE

notice

The mortise lock must feature a drill hole as specified in DIN 18251, otherwise SmartHandle 3062 cannot be installed. It is assumed that the mortise lock has been fitted according to instructions.

  1. Align drilling template precisely.
  2. The cut for the spindle must be positioned exactly over the retainer opening in the door lock.
  3. The template must be positioned completely parallel to the door edge. The dimension lines act as a reference.
  4. The centre hole must fit precisely over the hole in the lock.
  5. Use a suitable pen or pencil to mark the required drill holes.
  6. Place drilling template back on again to check the marks are correct.
  7. Dismount door lock from door.
  8. Drill top hole with a suitable 8-mm drill bit.
  9. Drill middle hole with a suitable 8-mm drill bit.
  10. Drill lower hole with a suitable 13-mm drill bit. It is recommended to pre-drill the hole with a 8 mm bit first.
  11. Re-fit door lock to door.