Step 0: Preparing drill holes - SmartHandle 3062

NOTE

notice

Please remove the lock from the door before drilling to prevent it from becoming damaged! The lock can be reinstalled in the door once you have completed drilling.

  1. Align drilling template precisely.
  2. The cut for the spindle must be positioned exactly over the retainer opening in the door lock.
  3. The template must be positioned completely parallel to the door edge. The dimension lines act as a reference.
  4. Use a suitable pen or pencil to mark the two drill holes.
  5. Place drilling template back on again to check the marks are correct.
  6. Drill top hole with a suitable 8 mm drill bit.
  7. Drill lower hole with a suitable 13 mm drill bit. It is recommended to pre-drill the hole with a 8 mm bit first.