Installation instructions SnapIn - SmartHandle 3062

• Batteries are already installed when the product is delivered!
• When installing the electronic SmartHandle 3062, ensure that there are no sources of low-frequency interference in the surrounding area.
• SmartHandle 3062 must be fitted, so that it is flush with the door. You must install the product as specified to ensure that it is structurally stable and will have a long service life.
• You must not strike parts of SmartHandle 3062 during installation.
• The two inlays in the cover are locked into position with a clip mechanism. These may only be removed using the SimonsVoss installation tool.
• In the case of fire retardant doors, you must ensure that the supplied profile cylinder inlay is pressed against the snap-in mechanism in the inside fitting.
• No water or moisture must penetrate the door or reach the inner side. Always use the WP version for moisture.
• Programme SmartHandle 3062 before installing.
• SmartHandle 3062 may be difficult to fit in mortise locks with a retaining nut. You must not alter the retaining nut in any way, using a file, for example; otherwise, the handle's guide piece will no longer fit accurately.
• When installing SmartHandle, you must ensure that the cable does not get caught or fitted too tightly to the door.