Step 1: Installing the fastening screw sensor - SmartHandle 3062

NOTE

notice

The fastening screw sensor may not be in locked final position during installation. The fastening screw sensor must be in the displayed "INSTALLATION" position; otherwise ("LOCKED") the outer ring must be pushed back carefully so that the spring mechanism is tensioned.

  1. Insert the end of the fastening screw sensor cable (B) (with plug) into the sensor screw drill hole.
  2. Use a suitable tool (e.g. tweezers) to guide the plug out of the profile cylinder opening on the inner side.
  3. Insert fastening screw sensor into the sensor screw hole until it will go no further.
  4. A spring mechanism holds the fastening screw sensor in place in the door lock.