Restore storage mode for conventional fastening system - SmartHandle 3062

  1. Disconnect the 3-pole cable from the inside fitting with the 3-pole cable from the outer fitting. If necessary, also disconnect the LockNode cable from the inside fitting.
  2. Hold the inside and outer fittings firmly while pulling them away from one another horizontally.

Fitted to the door:

NOTE

notice

General instructions: Depending on the handle model, it may not be possible to remove the inlay immediately. In such a case, push the inlay through the opening in the cover and remove the cover. The inlay remains on the handle and cannot be removed until the handle is dismounted.

Follow the same steps as for installation but in reverse order.