Step 5: Installing the inside handle - SmartHandle 3062

  1. Position the internal cover (10) on the internal fitting without fastening it. Notice that the cover can only be placed onto the fitting in one direction.
  2. The cover is positioned flush on the internal fitting but without fastening it.
  3. Push inlay (11) onto the internal handle retainer. Ensure that the black side of the inlay is turned towards the door.
  4. Insert inside handle horizontally into the outer fitting in the desired direction (DIN left or DIN right).
  5. The internal handle is placed in the internal fitting without being fastened.
  6. Tighten the headless screw to fasten internal handle.
  7. The inner door handle is now firmly linked to the SmartHandle.
  8. Check the handle mechanism to ensure it opens easily.
  9. Repeat the procedure described in this section if the outer should catch or jam.

NOTE

notice

For easier installation, the cover can usually also be slid over the inlay later in chapter "Step 6: Fastening the covers".