Procedure for freeze mode (G2) - SmartHandle 3062

If battery warning levels 1 and 2 are not observed or the locking system administrator has not been informed, the SmartHandle 3062 automatically switches to freeze mode. In order to avoid complete discharge in this state, the SmartHandle 3062 can then no longer be addressed with user IDs.

NOTE

This state should never occur because the batteries have to be changed at an early stage, i.e. at battery warning level 1!

The system administrator is required to open the door or replace batteries (see Battery Replacement section for further details). The administrator will need to carry out the following steps if the door is locked: If the door is open or when the battery side is accessible, the first point does not apply.

• If the door is locked, the administrator will need to activate the door with a battery replacement ID medium, thus eliminating freeze mode.
• Address SmartHandle 3062 with an authorised identification medium and open the door.
• Replace the batteries.