General instructions - SmartHandle 3062

• Only trained specialists may carry out installation and programming or replace the batteries.
• Do not touch electronics/components; do not allow them to come into contact with oil, paint, moisture, alkali or acids.
• The electronics must not be subject to mechanical stress or damaged in any way.
• The batteries used may pose a fire or burn hazard if handled incorrectly. Do not recharge, open, heat or burn these batteries. Do not short-circuit!
• Only use batteries which have been approved by SimonsVoss.
• Do not touch the contacts on the new batteries with your hands when replacing the old ones. Use clean gloves free of fat or grease to handle the battery.
• Damage may be caused to SmartHandle 3062 if you reverse the battery polarity.
• Dispose of old and used batteries in the proper manner and store them out of children's reach.
• Always replace both batteries when changing batteries!
• All SmartHandle 3062 must be operated with two batteries in the inside fitting! Hybrid variants delivered up to January 2016 are operated with four batteries (two in the inside fitting, two in the outer fitting). Hybrid variants (black battery holder with cover) delivered after this are only operated with two batteries in the inside fitting. The battery is changed as with non-hybrid variants.