Step 3: Install fittings - SmartHandle 3062

  1. Thread in installation tool for cables into the outer fitting with the plugless side in front from the direction of the adapter plate.
  2. The installation tool extends over the bottom of the outer fitting by just a few centimetres.
  3. Attach outer fitting onto the door from the outside and at the same time feed the end of the installation tool with the plug through the lock to the inside of the door.
  4. The three sleeves of the outer fitting construction are fit in the previously drilled holes and the cable of the installation tool protrudes outward from the inside of the door. The outer fitting construction is flush and parallel with the door.
  5. Adapter plate for the inside fitting (A) to the inside door and fasten iwth a screw (X2) with the centre sleeve of the outer fitting construct. Feed the cable of the installation tool through the long slot of the adapter plate.
  6. The outer fitting stops by itself at the door and the cable of the installation tool protrude to the inside of the door.
  7. All drill holes must be flush!
  8. Connect the cable of the inside fitting with the installation tool.
  9. Push the inner fitting (7) spindle through the lock's retainer slot and push the inner fitting, so that it is flush on the door. At the same time, by pulling on the installation tool from the outer side of the door, pull the cable of the inside fitting to the outer fitting.
  10. Fasten inside fitting with two screws (X2).
  11. Connect the connection cable of the inside fitting with the installation tool.
  12. Check the outer handle to ensure it opens easily. The handle must always return to its starting position by itself.
  13. If the handle catches, repeat the steps of this chapter. Check whether the fittings are aligned parallel and that the screws are not pulled too night.