Step 1: Preparing the fittings - SmartHandle 3062

Separate the halves

  1. SmartHandle programmed.
  1. Disconnect the three-pin cable that connects the inside fitting and the outside fitting.
  2. If necessary, also disconnect the cable of the LockNode of the inside fitting.
  3. Loosen the screw connection that connects the inner and outer fittings.
  4. Dispose of the screw and the plastic sleeve.
  5. Halves are separated.

Prepare the cable

  1. Use the opening tool to push the foam insert to the side.
  2. Guide the cable past the foam insert and down out of the fitting without kinking it.
  3. The cable is prepared.

Attaching damper foams

  1. Glue the damper foams to the fittings as shown.
  2. Damper foams are glued on.