Product specific safety notices - SmartHandle 3062

WARNING

warning

Mounting on fire and smoke protection doors

The SmartHandle 3062 meets the requirements for installation on fire and smoke protection doors. All relevant proofs and certificates can be found on our homepage under certificates.

There may be additional requirements for fire and smoke protection doors.

  1. When installing electronic fittings, please pay attention to the door's requirements relevant for approval.
  2. In case of doubt, contact the exhibitor of the approval.

CAUTION

caution

Combination with SVP lock

SmartHandle must be combined with a self-locking panic lock to guarantee all functions work correctly.

  1. Observe the lock manufacturers' Declaration of Conformity as per EN 179.

IMPORTANT

Material damage through drilling error

When you drill, you can cause damage to the door or the product if unsuitable tools are used. The SimonsVoss Technologies GmbH accepts no responsibility for material damage due to drilling errors.

  1. Observe safety instructions on drill.

Malfunction due to moisture

If the exterior of the door is outside or in areas with a high level of humidity (bathrooms or laundries), then use the WP version. All cable connections are then drawn into the interior area. The inside of the WP version is not protected against moisture.

  1. Always use a WP version where the outside could come into contact with moisture.
  2. Ensure that no moisture can reach the inside of the door.

Damage to the cables/cable connections

If you pull the cables, the cable connections or the cable itself could be damaged.

  1. Do not pull the cables.
  2. Disengage and separate the plug connectors carefully.

Loss of the precise guidance of the handle

It may be difficult to install on mortise locks with a retaining nut.

  1. Do not mechanically alter the locking nut. The handle would then lose its precise guidance.

Freeze mode due to separate storage

If you store the housing halves separately for a longer period of time (more than a week), SmartHandle may switch to freeze mode.

  1. Only separate the two halves of SmartHandle when installing it.

Mechanical damage to the LockNode

If the cover is fitted or removed, the LockNode can be damaged.

  1. Fit or remove the cover carefully.
  2. In removal, be aware of the slit in the cover.

Mechanical damage to the SmartHandle due to obstructions

If the handle can hit the wall or other objects due to the installation location, it can become deformed or break off.

  1. In such situations, use a suitable door-stopper.

Mechanical damage to the handle through misuse as door-opener

Some doors are very heavy and solidly constructed. The handle is not suitable for opening such doors.

  1. Make suitable door openers available (suitable handles) to avoid misuse of the knob.

NOTE

notice

Qualifications required

Installation and initial operation require specialist knowledge.

  1. Only trained specialist personnel may install and put the product into operation.

Damage from unsuitable tool

Only use the SimonsVossfitting tool for assembly and battery changes.

Faulty orientation before fitting the conventional MO-version

The fastening holes and the spindle must be vertically aligned; otherwise, you may not be able to install the fitting. Use the drill-hole template.

Effect of theSmartHandle 3062

The SmartHandle 3062 affects only the latch of the mortice lock.

Programming with obsolete LSM version

New components can only be programmed with the current version of LSM.

Stiffness of the SmartHandle due to stiff mortice lock

If the mortice lock is stiff, the SmartHandle will also be stiff.

  1. Check that the mortice lock is free-moving.

Fitting error or incorrect order

If you make a mistake in measuring the door and order a SmartHandle, the SmartHandle will not fit.

  1. Check the dimensions of the door again before ordering.