Restore storage mode for SwissRound MO - SmartHandle 3062

  1. Disconnect the 3-pole cable from the inside fitting to the 3-pole cable from the outer fitting. If necessary also disconnect the cable of the LockNode from the inside fitting.
  2. Hold the inside and outer fittings firmly while pulling them away from one another horizontally.
  3. If necessary, loosen the hexagon screw in the inside door handle, but ensure that you only unscrew a little, so that the screw remains in the handle.
  4. Remove the inside handle from the inside fitting.

Fitted to the door:

NOTE

notice

General instructions: Depending on the handle model, it may not be possible to remove the inlay immediately In such a case, push the inlay through the opening in the cover and remove the cover. The inlay remains on the handle and cannot be removed until the handle is dismounted.

Follow the same steps as for installation but in reverse order.