Installing the fitting for CISA - Digital SmartHandle AX

  1. Door pre-drilled.
  2. PH2 screwdriver at hand.
  3. TX15 screwdriver at hand.
  4. Vernier calliper at hand.
  5. Saw at hand.
  1. Measure the door thickness.
  3. Mark the sawing points on the screws and spindle.
  6. Use a suitable saw to cut the screws and spindle.
  8. Insert the sleeve nuts into the adapter plate.
  10. Place the adapter plate on the electronic fitting.
  12. Align the holes in the adapter plate with the threads in the fitting.
  13. Fasten the adapter plate firmly in a criss-cross sequence (PH2, torque 1.1 Nm).
  16. Insert the spindle with the pin side into the fitting.
  18. Insert the fitting with the adapter plate and spindle into the door.
  20. Screw the fitting firmly into place in the centre (PH2, torque 1.1 Nm).
  22. Screw the adapter plate firmly into place below the keyhole (PH2, torque 1.1 Nm).
  24. Fasten the wood screw as described in the CISA documentation.
  26. Insert the dummy cylinder.

  27. NOTE

    notice

    Feed the blank cylinder into the hole using a screwdriver

    It is difficult to position the blank cylinder correctly, especially in thick doors.

    1. Insert a screwdriver into the hole in the blank cylinder.
    2. Position the blank cylinder using the screwdriver.
  30. Push the handle onto the outer fitting.
  32. Firmly fasten the grub screw on the outside handle (TX15; torque: 5.0 Nm).
  34. Screw the dummy cylinder firmly into place (PH2, torque 1.1 Nm).
  1. Fitting is now installed.