Installing the fitting - Digital SmartHandle AX

  1. Door pre-drilled.
  2. PH2 screwdriver at hand.
  3. TX15 screwdriver at hand.
  4. Vernier calliper at hand.
  5. Pincers at hand.
  1. For S, M and L: measure the door thickness.
  3. For S, M and L: determine the separation points on the cut-to-length screws L1 and L2.
  6. For S, M and L: trim the cut-to-length screws L1 and L2.
  8. For 7 mm spindle: place the adapter sleeve in the inner handle in such a way that the recess faces the grub screw.
  10. Determine your inner handle’s direction rotation as viewed from the inside: clockwise (clockwise = CW) or anti-clockwise (counter-clockwise = CCW).
  13. Insert the interchangeable plate into the inner handle as required.
  16. Press the spring plate on one side against the interchangeable plate so that the spring is compressed.
  18. At the same time, hook the spring plate tabs into the slot in the inner handle.
  20. Press down the spring plate bracket.
  22. The inner handle is now ready.
  24. For 7 mm spindle: insert the adapter sleeve onto the side of the spindle with the pin.
  26. Insert the spindle with the pin side into the fitting.
  27. Pin will snap into position in the mount.
  30. For 8.5 mm and 10 mm spindle: slide the adapter sleeve into the centre of the spindle. Use a punch and hammer to make an indent in the adapter sleeve to prevent it from slipping.
  33. Insert the fitting with the spindle into the door. Use adapter sleeves if necessary.

  34. Ø mortise lock fastening hole

    Adapter sleeves

    5.5 mm–6.3 mm

    No adapter sleeves

    6.4 mm–7.3 mm

    6.4 mm

    7.4 mm–8.7 mm

    7.4 mm

    ≥ 8.8 mm

    8.8 mm

  35. Insert the escutcheon base into the door with the sleeve nuts.
  36. Fasten both escutcheon bases together with the L2 screws (PH2, torque 1.1 Nm).
  38. Fasten the inner handle firmly with the L1 screws (PH2, torque 1.1 Nm).
  40. Fasten the set screw on the inner handle firmly (TX15, torque 5.0 Nm).
  42. For FH: insert the dummy cylinder.

  43. NOTE

    notice

    Feed the blank cylinder into the hole using a screwdriver

    It is difficult to position the blank cylinder correctly, especially in thick doors.

    1. Insert a screwdriver into the hole in the blank cylinder.
    2. Position the blank cylinder using the screwdriver.
  46. For FH: screw the dummy cylinder firmly into place (PH2, torque 1.1 Nm).
  48. Place the two cover plates with the notch facing downwards onto the escutcheon base and the inner handle.
  50. On the outside, place the cover with the notch facing downwards onto the escutcheon base.
  52. Fit the outside handle into position on the fitting.
  54. Firmly fasten the grub screw on the outside handle (TX15; torque: 5.0 Nm).
  1. Fitting is now installed.