Remove fitting (P1 - Scandinavian Oval) - SmartHandle AX Advanced

  1. 1.5 mm hexagonal wrench available.
  2. 4 mm Allen key available.
  1. For MO: remove the cylinder cover screws on the inner side (PH2).
  3. For MO: remove the cylinder cover.
  5. For MO: remove the cylinder screws on the inner side (SW4).
  7. For MO: remove the inner cylinder.
  9. For MO: remove the outer cam cylinder.
  11. Remove the fitting in the reverse order to installation.
  12. Loosen the cover by bending the inlay outwards using the special tool.
  13. Loosen the handle grub screw firmly (TX15).
  15. Insert a 1.5 mm hex key into the hole in the spindle mount in the module support.
  17. Bend the hex key to the side where the hole is located while pulling on the outside handle.
  1. SmartHandle AX Advanced is now removed.