Remove fitting (K1 - oval escutcheon holes) - SmartHandle AX Advanced

  1. 1.5 mm hexagonal wrench available.
  1. Insert a flat-head screwdriver (ideally angled) into the opening in the lower surface of the panels on the inside.
  3. Lever off the panels with the flat-head screwdriver.
  5. Remove the fitting in the reverse order to installation.
  6. Loosen the cover by bending the inlay outwards using the special tool.
  7. Insert a 1.5 mm hex key into the hole in the spindle mount in the module support.
  9. Bend the hex key to the side where the hole is located while pulling on the outside handle.
  1. SmartHandle AX Advanced is now removed.