Installing the fitting - SmartHandle AX Advanced
- Door pre-drilled.
- PH2 screwdriver at hand.
- TX15 screwdriver at hand.
- Caliper gauge at hand.
- Saw at hand.
- View the mortise lock from the outer side and insert the sleeve nuts for the mortise lock into the fastening plate, ensuring they align correctly.
You can identify the outer fastening plate by the absence of threads in the middle holes. 
- Insert the module support into the fastening plate.
- Slide the module support downwards.
- Module support snaps into place.
- Fasten the module support to the fastening plate with the 12 mm screws (PH2, torque 3.0 Nm).
- Measure the door thickness.
Size
Door thickness (mm)
Screws
S
32 - <37
M5×35
S
37 - 59
M5×40
M
57 - 79
M5×60
L
77 - 99
M5×80
X
97 - 192
M4 X
- Determine what screws are required for the door thickness measured.
- For door thickness X: screw the 10 mm screws, threaded sleeves and threaded rods together.
- For X: mark the sawing points on the threaded rods and spindle.
- Mark the sawing point on the spindle.
- When using X: shorten the screws with a suitable saw (4x).
- Trim the spindle with a suitable saw.
- Insert the spindle into the fitting.
- Insert the module support, the fastening plate and the spindle into the outer side of the door.
- Insert the sleeve nuts into the MO cover.
- Insert the sleeve nuts into the fastening plate.
- Screw the inner fastening plate firmly into place (PH2; torque 1.1 Nm).
- Use the 12 mm screws to fix the module support onto the fastening plate (PH2; torque: 3.0 Nm).
- Position the cover on the fastening plate at the bottom.
- Close the cover upwards.
- Slide the cover downwards.
- Cover snaps into place.
- Press the inlay into place.
- Fit the cover for the outer side as well.
- Fit the outside handle.
- Attach the inside handle.
- Use the grub screws to tighten both handles (TX15, torque 5.0 Nm).
- When using MO: fit the locking cylinder (SW4).
- SmartHandle AX Advanced fully installed.
