Installation - RouterNode 3

IMPORTANT

Adverse effect on reception due to interferences

This device communicates wirelessly. Wireless communication can be affected or may fail due to metal surfaces or interference.

  1. Do not fit the device to metal surfaces.
  2. Keep the device away from sources of electrical or magnetic interference.

Unauthorised access

If the electrical contacts in the device are short-circuited by unauthorised persons, undesired reactions may occur.

  1. Mount the device in an environment that is protected from unauthorised access.

Malfunctions due to weather conditions

This device is not protected against splash water and other weather influences.

  1. Mount the device in an environment that is protected from the weather.
  1. Push in the housing cover as shown and remove the cover.
  3. Hold the base plate in the required position and mark the drill holes.
  5. Drill the required holes with a suitable drill.
  6. Use suitable dowels and fasten the screws for the base plate into position.
  7. Place the base plate so that the screw heads are fed through the recesses.
  9. Slide the base plate so that the screw heads slide along the grooves.

  11. CAUTION

    caution

    Additional fixation for ceiling mounting

    The device may fall from the ceiling.

    1. Tighten the screws after sliding on the base plate.
  12. Place the cover on the base plate again.
  1. Installation completed.

If you need openings in other parts of the housing, you can modify the housing as follows:

  1. Power supply disconnected.
  1. Push the ribbed area laterally inwards and remove the housing cover.
  3. Check the required width of the housing opening. The height of the opening is approx. 7 mm. Each removed bar widens the opening by 4 mm.
  4. Select a location where you want to remove the bars.

  5. IMPORTANT

    Insufficient fit due to removed clips

    The housing cover is positioned and held by clips on the webs. If you saw off or break off these clips, the housing cover will no longer be held at this point.

    1. Do not remove any bars that have a clip over them.
    2. Do not damage clips during sawing.
  6. Use a suitable saw to saw through the bars at both ends of the desired opening to the base plate.
  7. Bend the bars back and forth at the desired opening until the bars break.
  1. The housing is designed to be mounted on a surface.

The device can be fitted horizontally, vertically and on the ceiling. You can fit it in a horizontal position easily and safely using the integrated mounting holes. It is also possible to install it on a top hat rail using an adapter (item code E-22035000).