Miscellaneous - LSM 3.5 SP3 Basic

  • Preferably hold unused TIDs in reserve if reserve stock is increased
  • If the reserve of a transponder group is increased, TIDs are used which have never been used within the locking system (if TIDs are still available). If the checkbox is not enabled, TIDs which have already been programmed into a locking device before, but are not being used at the moment are also used.
  • Show building structure
  • If this checkbox is enabled, the abbreviations for the building and the floor of the door selected (if available) are displayed before the door name in the "Door" column in the "Manage WaveNet" mask.
  • Optimise issuing of locking device IDs for card systems
  • If this checkbox is enabled and a configuration set in G2 card management with "L" or "L_AV", the LIDs must be issued as follows when new G2 locking devices are created:
    • The next free LID is used in the case of hybrid and MIFARE locking devices.
    • In the case of locking devices with active technology, an LID is issued which is above the LID range indicated for "Locking device IDs" in G2 card management.
  • Immediately delete the overwritten tasks for LSM Mobile from the database
  • If this checkbox is enabled, the previous export task for the same GUI user is deleted in the "Exported tasks" if a new task is carried out.

  • NOTE

    notice

    Export tasks for the same user which were completed before the checkbox was enabled are not automatically deleted.

  • Switch off access control during initial programming
  • Enable this checkbox if you do not wish to have any access control in the locking system in general, but still want to use time zone control. This function is then automatically disabled when new locking devices are created.
  • Disassociate reset transponder from holder
  • Enable this checkbox if the transponder needs to be disassociated from its user when it is reset and the transponder's serial number is to be replaced by the current date and time.
  • Do not change serial number when reset
  • Enable this checkbox if a transponder's serial number should not be reset when reset (for auditing reasons).