Installation - Digital Cylinder AX (Z5)

Disassembling the electronic thumb-turn

  1. Special tool available.
  2. 1.5 mm hexagonal wrench available.
  1. Align the thumb turn horizontally.
  3. Attach the special tool.
  5. Align the special tool so that the logo is parallel to the recess.
  7. Hold the special tool and thumb turn cap firmly at the same time and turn them together 1-2° clockwise first and then counter-clockwise.

  8. NOTE

    notice

    Slipping when turning

    The surface of the thumb turn cap can be slippery and the cap can be difficult to turn (especially with WP versions, recognizable by the blue cylinder neck ring or the lasered marking on the inner side of the cylinder profile).

    1. Wear non-slip gloves.
  10. Remove the tool and cover.
  12. Insert the hexagonal wrench into the hole provided until it stops.
  14. Turn the hex wrench 270 degrees counterclockwise.
  16. Pull out the hexagon wrench again.
  18. Pull off the thumb turn.
  1. Electronic thumb-turn is disassembled.

Insert extension

  1. Pull the centering bush out of the thumb-turn mount.
  3. Insert the extension piece into the thumb-turn mount.

  5. IMPORTANT

    Damage due to incorrect alignment

    The extension piece or its contact pins cannot be inserted if installed incorrectly.

    1. Check alignment of contact pins.
  7. Slide the pre-assembled clamp from the extension piece towards the driver until it slides into the groove provided.
  10. Push the circlip with the smaller diameter in the direction of the driver onto the thumb-turn mount as far as it will go.
  13. The clamp can no longer slip.

Installing the electronic thumb-turn

  1. 1.5 mm hexagonal wrench available.
  1. Align the thumb turn mount horizontally.
  3. Attach the thumb turn.

  6. NOTE

    notice

    Use the supplied hexagonal wrench.

    The special tool is supplied with a hexagonal wrench.

    1. Use this hexagonal wrench to mount and dismount the electronic thumb turn.
  7. Insert the hexagonal wrench into the hole provided until it stops.
  9. Turn the hex key 270 degrees clockwise.
  11. Pull out the hexagon wrench again.
  13. Put on the cover.
  16. Turn the cover clockwise.
  18. The cover snaps into place with one click.
  1. The electronic thumb turn is installed.