Reduce CO cylinders to HZ - Digital Cylinder AX (Z5)

You can recombine a Digital Cylinder AX to a half cylinder using a special centre piece.

  1. Lever for releasing the clip
  2. Spacer for aligning the extension bolt
  3. Clamping block for pressing in the clamp
  4. Half-cylinder centre piece
  1. Place the Digital Cylinder AX in the knob tool, electronic side facing up.
  3. Hook the tip of the lifter into the clip.
  5. Pry the clip out of the profile cylinder by moving the extractor to the centre of the cylinder.
  7. Pull the clip completely out of the profile cylinder.
  9. Separate the two halves of the cylinder.
  11. Erste Zylinderhälfte ohne Mittelstück vorbereitet.
  13. Place the spacer against the half-cylinder centre piece.
  15. Using the extractor, screw in a suitable extension bolt until it rests against the spacer.
  17. Place the prepared cylinder half into the Knauf fitting tool.
  19. Place the half-cylinder centre piece onto the prepared cylinder half.
  21. Verlängerungsbolzen ist gegen Verdrehen geschützt.
  22. Remove the spacer.
  24. Push the cylinder parts together fully.
  26. Reinsert the bracket, with the nose facing the faceplate screw, into the slot in the profile cylinder.
  28. Insert the cylinder into the clamping block so that the profile cylinder and the knob sit flush with the recesses.
  30. Der Hebel des Klemmblocks ist an einer Stelle mit einem Metallplättchen verstärkt. Die vorhin eingeschobene Klammer liegt gegenüber dieses Metallplättchens.
  31. Press the lever on the clamping block towards the base plate until the clamp is fully seated in the profile cylinder again.
  2. Digital Cylinder AX is assembled.