Installation on fitted cylinder (clockwise unlocking) - Digital Cylinder AX (Z5)

Removing the mechanical thumb-turn

  1. Special tool available.
  1. Align the thumb turn horizontally.
  3. Attach the special tool.
  5. Align the special tool so that the logo is parallel to the recess.
  7. At the same time turn the special tool and the thumb turn counterclockwise.
  9. Remove the special tool and the thumb turn at the same time.
  1. The mechanical thumb turn is disassembled.

Installing the escape thumb-turn

  1. 1.5 mm hexagonal wrench available.
  1. Insert the 1.5 mm hex key into the escape thumb turn.
  3. Turn the hex key fully clockwise until it comes to a stop.
  4. Escape thumb turn clicks.
  6. Pull out the hexagon wrench again.
  7. Place the escape thumb turn on the cylindrical shaft.
  9. Turn the escape thumb-turn clockwise until it engages.

Functional test

  1. Turn and pull the escape thumb-turn to check that it is properly locked in position.
  2. Check that you can unlock the door with the escape thumb-turn.
  1. Escape thumb turn is installed.