Plan the installation procedure - Step-by-Step SVCN

In SmartIntego projects set up on a SmartIntego Virtual Card Network (SVCN), you can prepare everything before installation. In general, commissioning consists of two main steps:

Infrastructure

First, create the conditions for installing a SmartIntego system:

  1. Install the integrator system.
  2. Configure the integrator system.
  3. Install the updater (= gateway where the cards are updated. Provided by the integrator or a third party manufacturer).
  4. Programme the cards.
  5. Hand out the cards (if not done yet).

Locking devices

  1. Receive the locks.
  2. Programme the locking devices.
  3. Mount the locking devices.

In general, the following steps are necessary during the setup of a SmartIntego project based on the SmartIntego Virtual Card Network:

  1. Label the components.
  2. Create the system documentation (see Document system). The system documentation shows what has been installed where.
  3. Install the SmartIntego tool (SVCN) (see Install SmartIntego Tool (SVCN)).
  4. Create a SmartIntego project.
  5. Set up your map configuration.
  6. Create your locking devices in the integrator's door administration system.
  7. Import the lock data into the SmartIntego tool (SVCN)
  8. Programme the locking devices.
  9. Export the lock data to the integrator's system

NOTE

notice

Functional test before installation

Before installing the lock in the door, a function test of the system (Lock, Card and Integrator System together) is strongly recommended. Without the function test, when installing the lock in the door, there is a risk that you may lock yourself out and no longer be able to open the door.