Password-protected data area - System description WO

If a data record is used on the card (with UID of the card or another unique ID), each card in the system has its own identification. This identification is stored in a password-protected area of the card.

Access rights to this area of the card are part of the card configuration and stored on the SmartIntego locking devices. After holding such a card, the locking device reads only this area.

Frequency

13.56 MHz (RFID)

Supported Reading Technologies

ISO 14443-A

Unique Identifier/Card Serial Number

Static or Random

Supported card types including configuration settings

  • Mifare Classic:
  • IsMad (0 or 1)
  • KeyType (KEY A or KEY B)
  • Key
  • MadAid
  • SectorList
  • Mifare Desfire:
  • AppID (decimal)
  • Communication Mode (Encrypted, plain or mac)
  • CryptoMode (AES, 3DES - 3DES not AX-compatible, convert to AES beforehand if necessary)
  • Datei-Nr.
  • ReadKey No.
  • ReadKey (hexadecimal)

Up to five such card configurations can be used simultaneously in a locking system. All card configurations are globally valid: All locking devices in the locking system use the same card configurations.

For each card configuration, it must be specified where the data relevant for the respective card configuration is located on the card.

The locking device should not read out the entire data record of the card. It only requires a number (max. 32 bytes) that uniquely identifies the card. In the area SI-Tool: Kartenmanagement - LOcation if the data (e.g. card ID) [offen] you specify which related data should be read out from the locking device.

SI-Tool: Kartenkonfiguration - Offset Online Connection (Bytes) [offen]

SI-Tool: Kartenkonfiguration - Length Online Connection (Bytes) [offen]

SI-Tool: Kartenkonfiguration - Offset Whitelist (Bytes) [offen]

SI-Tool: Kartenkonfiguration - Length Whitelist (Bytes) [offen]

  • Specifies from which byte the data is read.
  • Use for online access
  • Specifies how many bytes of the data are read.
  • Use for online access
  • Specifies from which byte the data is read.
  • Use for whitelist access
  • Specifies how many bytes of the data are read.
  • Use for whitelist access

The exact parameters can be found in the documentation of your integrator system.