Double-click simulation (block lock operation on block lock 3066) - PIN code terminal

You can use the PIN code terminal to activate SimonsVoss activation units (VdS Block Lock 3066). The PIN code terminal must be programmed in knowledge mode.

If the PIN code terminal is within transmission range and a correct User PIN has been entered, the activation unit is activated. The block lock then activates or deactivates the alarm system (see block lock manual).

The VdS-certified SimonsVoss activation units require a double opening protocol for activation/deactivation processes (=double click if a transponder is to be activated or deactivated). The PIN code terminal can simulate this double click and thus perform arming/disarming operations. The double-click simulation is not activated ex works. You can activate and deactivate double-click simulation at any time.

IMPORTANT

Malfunctions due to double-click simulation

The double-click simulation is only intended for operation with a SimonsVoss Block Lock 3066. It can cause malfunctions on other components.

  1. Activate double-click simulation only if you are using a SimonsVoss Block Lock 3066!

NOTE

notice

Battery warning locks programming

If one of the two battery warning levels is active, the programming cannot be changed.

  1. Replace the batteries (see Battery replacement).
  2. Change the programming as required.

Programming aborted due to timeout

The PIN code terminal cancels the entry after five seconds without pressing a button. The entry will then not be accepted or the previous settings will be retained.

  1. You can cancel the entry by no longer pressing any keys.
  2. In this case, start the input from the beginning.

Enable double-click simulation

  1. Press 0 for more than two seconds to activate programming mode.
  2. PIN code terminal beeps and flashes orange once.
  3. Enter the Master PIN.
  4. Enter 07.
  5. Enter 1.
  6. PIN code terminal beeps and flashes green twice.
  1. Double-click simulation is activated.

Deactivate double-click simulation

  1. Press 0 for more than two seconds to activate programming mode.
  2. PIN code terminal beeps and flashes orange once.
  3. Enter the Master PIN.
  4. Enter 07.
  5. Enter 0.
  6. PIN code terminal beeps and flashes green twice.
  1. Double-click simulation is disabled.

Check double-click simulation

  1. Press 0 for more than two seconds to activate programming mode.
  2. PIN code terminal beeps and flashes orange once.
  3. Enter the Master PIN.
  4. Enter 07.
  5. Enter 2.
  6. PIN code terminal beeps and flashes green twice.
  1. If activated: PIN code terminal beeps and flashes green once.
  2. If deactivated: PIN code terminal beeps and flashes orange once.