Unlock user with initial PIN - PIN code terminal

Provide a message with initial PINs for each user. With this initial PIN, your users activate themselves at the PIN code terminal and select their own User PIN.

  • Individual for each user
  • Can be used once, then blocked
  • (Exactly one specific user can unlock themselves with exactly one specific initial PIN at exactly one specific PIN code terminal.)

Issue message with initial PINs

  1. LSM open.
  2. User created (see Creating users).
  3. Locking device created and configured for PIN code terminal (see Preparing locking devices in LSM).
  1. Open the properties of your locking system using Edit - Locking system properties.
  2. Change to the PIN-Code Terminal tab.
  3. In the section PIN code user, select all entries of the user whose initial PINs are to be issued in the message.
  5. Click on the Initial-PINs button.
  6. Message with initial PINs is issued.
  7. Give the user the message with their initial PINs.

Activating users

Previously created users (see Creating users) are enabled with a numerical code:

The user selects their User PIN themselves. The User PIN must meet the following requirements:

The example shows the activation for a User PIN with eight digits. If the length of the is User PIN not eight digits, then the length of the numerical code is different.

  1. Message with matching initial PIN is available.
  2. Master PIN changed (see Changing the master PIN).
  1. Press 0 for more than two seconds to activate programming mode.
  2. PIN code terminal beeps and flashes orange once.
  3. Enter 01.
  4. Enter the transponder ID from the message.
  5. Enter the remaining initial PIN from the message.
  6. Enter your desired User PIN.
  7. Re-enter your desired User PIN.
  8. PIN code terminal beeps and flashes green twice.
  1. User PIN is ready for use.