Replacing batteries starting in 03/2026 (Scandinavian Oval, reader on both sides) - SmartHandle AX Advanced SmartIntego

NOTE

notice

Malfunctions due to poor contact or different discharge

Contact surfaces that are too small/contaminated or different discharged batteries can lead to malfunctions.

  1. Only use batteries that are approved by SimonsVoss.
  2. Do not touch the contacts of the new batteries with your hands.
  3. Use clean and grease-free gloves.
  4. Always replace all batteries at the same time.
  1. Special tool at hand.
  2. PH2 screwdriver at hand.
  3. SW4 screwdriver available.
  4. Gloves at hand.
  1. For MO: remove the screws holding the cylinder (SW4).
  3. For MO: pull out the inner cylinder.
  5. For MO: pull out the cam cylinder.
  7. Insert the special tool into the cover inlay on the electronics side.
  9. Use the special tool to carefully bend the cover inlay upwards.
  11. Slide the cover upwards.
  13. Cover unlocked.
  14. Remove the cover.
  16. Use the special tool to detach the battery module clip.
  18. Remove the battery module.
  20. Pull the battery carrier out of the battery module.
  22. Remove the batteries.
  24. Insert the new batteries as shown. Slide the batteries into the battery carrier in pairs with the positive poles facing each other.
  28. Put the battery carrier back into the battery module.
    The batteries point towards the nose of the battery module and the spring contacts upwards.
  31. Put the battery module back into the module support.
  34. Use the special tool to reattach the battery module clip.
  36. SI SmartHandle AX Advanced will beep three times.
  37. Position the cover on the fastening plate at the bottom.
  39. Fold the cover upwards.
  41. Push the cover against the door while sliding it downwards at the same time.
  43. Cover snaps into place.
  44. Press the inlay into place.
  45. For MO: screw the inner cylinder and outer cam cylinder together again (SW4).
  1. Batteries are now replaced.