Installation Z4.MP.KA.SET - Locking cylinder (Z4) 3061

Freely rotating, digital locking cylinders only (except AP2.FD).

  1. Use the installation tool to remove the outer thumb-turn.
  2. Attach core protection adapter. While holding the inside thumb-turn, rotate until the adapter locks into the locking cylinder, so that it is flush.
  3. The notches on the core protection adapter now fit flush into those on the core tube.
  4. Fasten core protection adapter using the supplied clip, as shown in the diagram:
  5. The two markings point in the direction of the core protection adapter.
  6. The clip must lock into position correctly on the core protection adapter.
  8. Check whether the clamp is fastened flush with the core protection adapter.
  9. Push locking cylinder into the door from the inside.
  10. Fasten locking cylinder with the fastening screw.
  11. Use the installation tool to fit outer thumb turn to the locking cylinder.