Installation of core extraction protection adapters (Z4.KA.SET) - Locking cylinder (Z4) 3061

The core extraction protection adapter (Z4.KA.SET) is compatible with all SKG/VdS cylinders manufactured up to 2010 and all .FD cylinders.

Instructions:

  1. Disassemble the non-electronic knob.
  2. Remove the rubber seal on the tip of the outside tube.
  3. Place the core extraction protection adapter on the outside tube and turn while applying a little pressure, so that it grips into the indents on the flange (in a similar way to the knob when installed). The openings in the adapter and the outside tube web must align.
  4. Insert the supplied screw through the lock and tighten carefully.
  5. Replace the knob and turn in an anti-clockwise direction while applying slight pressure until the outer knob grips into the indents in the flange. Possibly place the knob in this position by pressing it gently towards the profile cylinder housing.

  6. NOTE

    notice

    Turning the bayonet disc when not installed may prevent the thumb-turn from being fastened into position. In such a case, push the disc back into the original 'bayonet disc open' position using the installation tool.

  7. Place the installation key on the outside thumb-turn in such a way that its two teeth engage into the outside thumb-turn (if necessary, turn the thumb-turn until both teeth lock into the locking disc). Lock the thumb-turn into position again by rotating it 30° in a clockwise direction.