Programming the transponders - PIN code keypad (offline)

Each PIN is assigned to one of the three integrated transponders.

PIN

Transponder

User PIN 1

Transponder 1

User PIN 2

Transponder 2

User PIN 3

Transponder 3

NOTE

notice

No access due to incorrect assignment

If you do not observe the assignment, a user may not be able to use their User PIN.

  1. When programming, select the correct number of the corresponding User PIN!
  2. Check the assignment after programming by activating a locking device (see Opening).

Create entry for the User PIN

  1. In the LSM software (same locking plan), click on the button New transponder .
  2. The window New transponder opens.
  3. In the dropdown menu Type select the entry G1 Pin code.
  4. Click on the OK button.
  5. Window closes.
  1. The entry for User PIN is created.

Repeat these steps for all other User PINs that you want to create.

Programming PIN code keypad 3068

  1. Select the User PIN entry in the matrix.
  2. Open the context menu by right-clicking on the entry of the User PIN in the matrix.
  3. Select the context menu entry Programming.
  4. The window Transponder Programming opens.
  5. Enter the number sequence 00.
  6. Enter the Master PIN.
  7. Click on the Programming button.
  8. Enter the number of the User PIN (for example, 1 for User PIN no. 1).

  9. NOTE

    notice

    Radio error

    If you hold the transponder too close to the programming device or activate the transponder too early, the radio link cannot be established.

    1. Keep a distance of about 20 cm!
    2. Do not activate the transponder until you are prompted in the LSM software to press the transponder button.
  10. Programming is performed.
  11. PIN code keypad 3068 beeps and flashes green twice.
  1. Programming successful window is displayed.
  2. User PIN was linked to the entry in the matrix.

Repeat the programming for all other User PINs that you want to assign.

If you do not want to use all User PINss, leave them unprogrammed.