Installation instructions MO - SmartHandle SmartIntego

• Batteries are already installed when the product is delivered!
• When installing the digital SI:SmartHandle, ensure that there are no sources of (low-frequency) interference in the surrounding area.
• The SI:SmartHandle must be fitted, so that it is flush with the door. You must install the product as specified to ensure that it is structurally stable and will have a long service life.
• You must not strike parts of the SI:SmartHandle during installation.
• The two inlays in the cover are locked into position with a clip mechanism. These may only be removed using the SimonsVoss installation tool.
• No water or moisture must penetrate the door or reach the inner side. In case of moisture, always use the WP version.
• Programme the SI:SmartHandle before installation!
• The SI:SmartHandle may be difficult to fit in mortise locks with a retaining nut. You must not alter the retaining nut in any way, using a file, for example; otherwise, the handle's guide piece will no longer fit accurately.
• When installing SmartHandle, you must ensure that the cable does not get caught or fitted too tightly to the door.
• Conventional fastening system, including MO: When fitting the handle into position on the door with the two screws, make sure that the electronics are not subject to mechanical load and are not damaged in any other way.
• For MO: The mechanical cylinder is not included in the supplied package for the SI:SmartHandle with MO.
• Always install a locking cylinder. If necessary, use a blank cylinder.