Installation instructions - SmartHandle SmartIntego

• Batteries are already installed when the product is delivered!
• When installing the electronic SI:SmartHandle, ensure that there are no sources of low-frequency interference in the surrounding area.
• SI:SmartHandle must be fitted, so that it is flush with the door. You must install the product as specified to ensure that it is structurally stable and will have a long service life.
• You must not strike parts of SI:SmartHandle during installation.
• The two inlays in the cover are locked into position with a clip mechanism. These may only be removed using the SimonsVoss installation tool.
• No water or moisture must penetrate the door or reach the inner side. Always use the WP version for moisture.
• Programme SI:SmartHandle before installing.
• SI:SmartHandle may be difficult to fit in mortise locks with a retaining nut. You must not alter the retaining nut in any way, using a file, for example; otherwise, the handle's guide piece will no longer fit accurately.
• When installing SmartHandle, you must ensure that the cable does not get caught or fitted too tightly to the door.
• Conventional fastening system: When fitting the handle into position on the door with the two screws, make sure that the electronics are not subject to mechanical load and are not damaged in any other way.