Installation - SmartIntego Locking cylinder (Z4)

  1. Remove the metal discs on the inside tube and push a plastic disc onto it instead. You will find the plastic disc in the supplied package.
  2. Push the removed metal discs onto the inside tube, so that a plastic disc and a varying number of metal discs, depending on the half cylinder type, are on the inner tube.
  3. Push the inner tube thumb-turn into the profile cylinder housing until it stops.
  4. Engage cylinder using an authorised ID medium.
  5. While the thumb-turn is engaged, press it gently against the profile cylinder housing while turning clockwise at the same time until the inside tube clicks into place in the profile cylinder housing.

NOTE

notice

Check that it has locked into position correctly by pulling the thumb-turn gently while turning it backwards and forwards.

NOTE

notice

You will find the required plastic discs in the supplied package.

When installing, ensure that only one plastic disc and the same number of metal discs are on the inner tube as when you took it apart. The plastic disc must be placed directly on the thumb-turn.