SI online battery warning - SmartIntego Locking cylinder (Z4)

Online via the system
In SmartIntego Online, a low battery status is signalled to the system by a designated bit when a booking (locking device event or 'Get status') is made. The system integrator must take this bit into account – by creating suitable warnings, for example – to prevent SI-Locking Cylinder from discharging completely.
It can take up to 24 hours before the SI-Locking Cylinder resets the battery warning after a battery replacement.
On site at the locking device
It is also possible to use the SmartIntego tool to programme a battery replacement card. If you hold this card up to the card reader on the locking device, an internal resistance test is performed immediately, serving as a battery test. The warning on the locking device is immediately reset if the batteries have been replaced after a battery warning and a battery replacement card is used to complete an internal resistance test on the locking device concerned.
In this case, no freeze mode or escalation levels are created, only information transmitted by the 'Event' or 'GetStatus' (such as a warning or alarm), which the ACP needs to evaluate.