Battery replacement - G2 Transponder

The transponder battery can be replaced at any time.

  1. Carefully open the casing at the notches, so that you can see the battery.
  3. Open the battery holder.
  4. Remove the battery.
  5. Insert a new battery (negative pole to the circuit board).
  7. Close the battery holder.
  8. Press the casing together again.
  9. Casing lid clicks back into place.
  1. Battery is replaced.

WARNING

warning

Risk of explosion due to incorrect battery replacement

A battery fitted incorrectly into a explosion protection transponder may ignite an explosive atmosphere. Therefore, only SimonsVoss Technologies GmbH may replace the battery in explosion protection transponders.

CAUTION

caution

Lack of power supply on battery replacement

The transponder may lose data due to the interruption in power supply. Do not interrupt the power supply for longer than two minutes. Do not press the button when there is no power and avoid short circuits.