Initial operation - SmartRelay, SmartRelay G2

Check

  1. Unpack SmartRelay and check for any damage.
  2. Connect SmartRelay to a power supply or a battery.
  3. Activate the SmartRelay with a transponder and test whether the SmartRelay responds to activation in some way or other.

Programming

Programme the SmartRelay with the appropriate software, e.g. LSM Software for SmartRelay 3063. The SmartRelay must be connected to a power source for the programming process. You will find the details on programming in the LSM Software here: Configurations in the software

Connection and installation

  1. The SmartRelay is not connected to any power source and is in a de-energised state.
  1. Use backup battery: The positive terminal on the 3V-CR1220 battery faces upwards in all SmartRelays.
  2. Connect all cables to their designated terminals on the SmartRelay (see Connections)
  3. Switch on the power supply (connect the plug or battery if required).
  4. Use an authorised transponder to test the programmed SmartRelay.
  5. Install SmartRelay.
  6. Remove the housing if you install in a flush-fitted masonry box. SmartRelay circuit boards come in two different sizes. Check that the SmartRelay circuit board fits into your flush-fitted masonry box before installing SmartRelay.
  7. If mounted on the surface, the base plate can be used as a template for the drill holes (6 mm).

NOTE

notice

The backup battery must not be used if SmartRelay is powered by a battery (SREL.BAT).