Shorten Cylinder AX - Digital Cylinder AX (Z5) Modularity

You need a bolt for the desired length.

  1. Extractor for releasing the clamp
  2. Spacer for aligning the bolt
  3. Clamp block for pressing in the clamp
  1. Place the Cylinder AX in the thumb-turn assembly tool.
  3. Hook the tip of the extractor into the clamp.
  5. Lever the clamp out of the profile cylinder by moving the extractor to the centre of the cylinder.
  7. Pull the clamp completely out of the profile cylinder.
  9. Disassemble the two cylinder halves.
  11. Unscrew the bolt with the extractor.
  13. Remove the profile extension.
  14. Remove the core extension.
  16. Place the spacer.
  18. Screw in a suitable bolt with the extractor until it rests on the spacer.

  19. NOTE

    notice

    Length on bolt head

    You will find a number on the bolt head. This number is the length of the cylinder profile to which the bolt fits.

  21. Reassemble the two cylinder halves.
  23. Bolt is protected against twisting.
  24. Pull the spacer off again.
  26. Push the halves together completely.
  28. Refit the clip into the slot of the profile cylinder with the lug facing the fastening screw.
  30. Insert the cylinder into the clamping block so that the profile cylinder and the thumb-turn lie flush in the recesses.
  32. The lever of the clamping block is reinforced at one point with a metal plate. The bracket that was previously inserted lies opposite this metal plate.
  33. Push the clamp block lever towards the base plate until the clamp is fully seated in the profile cylinder.
  1. Cylinder AX is shortened.